Isp-technologies THETA 212 Combo Bedienungsanleitung Seite 1

5. CHANNEL SELECT SWITCH The CHANNEL SELECT switch changes the COMBO operating channel from CLEAN to DISTORT. The CHANNEL SELECT switch i

THETA FOOTCONTROLLER 1. PREAMP1 SWITCH This switch turns on and off PREAMP1 the CLEAN channel preamp on the THETA. 2. PREAMP1 LED When th

THETA COMBO SPECIFICATIONS Power: Bass Control /Preamp 1 and 2: Bass Control /Clean and Distort: Mid Sweep Frequency /Preamps: Mid Sweep Fre

WARRANTY AND SERVICE The Internal Circuitry is fully guaranteed to be free of defects under normal use and service for a period of three years fro

INTRODUCTION Congratulations on your purchase of the Theta Combo 212 Combo Guitar cabinet. You are now the owner of the most innovative guita

FUSE REPLACEMENT 1. Use a small screwdriver as shown to slide the fuse cover out from the power inlet module. The fuse can be found i

FRONT PANEL Understanding the THETA COMBO amplifier COMBO PREAMP1 1. PREAMP1 ON LED This led indicates when PREAMP1 is active and in

4. MIDRANGE BOOST/CUT CONTROL This control works in conjunction with the SWEEP frequency control 5. The MID and SWEEP controls work to

COMBO CLEAN CHANNEL 1. CLEAN CHANNEL ON LED This led indicates when the CLEAN CHANNEL is active. NOTE: The CHANNEL SELECT switch on the FOOTCONTR

5. SWEEP FREQUENCY CONTROL This control works in conjunction with the MID boost/cut control and adjusts the center frequency of the MID boost or

9. LEVEL CONTROL The LEVEL control adjusts the output LEVEL of the CLEAN channel. NOTE: The final output level is determined by the se

6. TREBLE CONTROL The TREBLE control adjusts the boost or cut that is applied in the high frequency portion of the spectrum of DISTORTION CHANNEL. T